3-Axle 40ft Stake Flatbed Trailer — General Cargo Platform for Steel, Lumber and Building Material Haulage
3-axle 40ft stake flatbed trailer with removable stanchions, front headboard, side D-rings and 12 twist locks. Hauls steel, lumber, cement bags, machinery and containers. Factory direct from Vehicle Master.
Axles: 2/3/4 Axles
Loading Capacity: 20-80 Tons
Delivery time: 15~30 days
Shipping: RoRo/bulk/container/SKD/CKD, etc.
Price: Factory Price. Contact Us for A Free Quote.
Whatsapp/Phone: +86 13698615216
Email: global.sales@vehiclemaster.com
Description
When most people hear the term "flatbed", they imagine a chassis built to haul a 40ft container - and that is just one of its uses.But in Mombasa, Lagos, Jakarta, Karachi and Istanbul, the same 40ft flatbed spends more of its year hauling steel pipes, rubber logs, palletized cement bags, bundles of rebar, and pre-cast concrete beams than it ever spends on containers.
The difference between a container chassis and a real general-cargo flatbed is not the frame - it is the stake sockets, the side D-rings, the front headboard, and the anti-slip deck. This page is about that version.
What This Trailer Actually Hauls (and How You Strap It):
We group the cargo into four categories. Each one uses a different part of the trailer.
- Steel loads - pipes, plates, bundled rebar, coils
This is the heaviest regular job. A 12m length of 12-inch steel pipe weighs about 2.8 tons. Three stacks across the deck = 18 tons of pipe, plus the rig. The deck uses 3mm checkered steel plate (not smooth plate - smooth plate lets pipe skate sideways under braking). We weld two rows of D-rings along each side (8 per side, 1.5m spacing) so you can run a ratchet strap over the top of each pipe stack without the strap sliding off. For round items like pipe or coils, you need wooden chocks welded or chained at the front and rear of each stack - a 3-ton pipe that rolls forward on hard braking does not ask permission before it goes through the cab.
- Lumber - logs, sawn timber, plywood bundles
Logs and sawn timber are why the stake sockets exist. We drill 20 stake sockets along the bed (10 per side), so you drop 4-inch steel posts into the holes and run a wire rope or chain around the whole load. Without stanchions, a 6m tall stack of logs can shift 30 cm on the first sharp turn - enough to slide off the trailer deck when navigating a roundabout. Plywood and sawn timber are lighter, typically palletized, and only require top strapping.
- Building materials - cement bags, blocks, bricks, pre-cast beams
Cement bags in 1-ton jumbo bags or 50kg sacks on pallets need a front headboard (the 400mm steel wall at the front of the bed). On an emergency stop, 20 tons of palletized cement does not compress - it keeps moving. The headboard is what stands between that pallet and your driver's cab. Blocks and bricks are usually tarped; we mount four tiedown points at the front of the headboard so the tarp bungee hooks down tight in crosswinds.
- Machinery and palletised loads
A small excavator, a generator, a forklift, or palletized goods. For this job you leave the stakes out, drive on from a ramp (or use a forklift), and tie through the D-rings. If you need to carry a 40ft container occasionally, the 12 twist locks (4 front, 4 mid, 4 rear) bolt into the same frame - you do not need a separate chassis for one container trip a month.
Quick Spec Reference (Stake & Sidewall Version)
| Item | Specification |
|---|---|
| Deck Length | 12,500 mm (40ft) |
| Deck Width | 2,500 mm |
| Deck Height | 1,500 mm |
| Deck Surface | 3mm checkered steel plate (anti-slip) |
| Main Beam | Q345 I-beam, 14mm web |
| Axles | 3 × 13t FUWA / BPW |
| Suspension | Mechanical leaf spring, 90mm × 13mm × 10 leaves |
| Stake Sockets | 20 positions (10 per side), accepts 100×100mm posts |
| Front Headboard | 400mm steel, 4 tiedown points on top |
| Side D-Rings | 16 total (8 per side), rated 2,000kg each |
| Twist Locks | 12 (removable, for 20ft or 40ft containers) |
| Sideboards (optional) | Removable steel, 400mm / 600mm height |
| King Pin | JOST 3.5" |
| Landing Gear | JOST 28t two-speed |
| Brakes | WABCO air + ABS |
| Tires | 12R22.5 × 12 |
| Curb Weight | ~6,800 kg |
| Payload | 30–35 tons (general cargo) |
Three Strapping Mistakes That Get Drivers Fired (or Worse)
We have seen these on every continent. They are not abstract safety notes - they are the reason a load ends up on the roadside.
- Strapping only the top layer of a tall load. A 3m-high lumber stack secured with just two top straps may seem stable. But the bottom layer can shift separately from the top. Each layer needs its own strap, or the whole stack will slide sideways.
- No chocks on round items. A steel pipe or a log held only by a strap will roll. Strap tension is vertical; rolling is horizontal. You need wooden or steel chocks front and rear to stop the roll before the strap even takes the load.
- Skipping the front headboard for heavy forward-placed loads. If you walk into a job where the headboard was removed "to save weight," do not load anything heavy near the front. The first panic stop puts that load through the cab wall.
We build the headboard welded on, not bolted, for this reason. If you want it removed for a specific over-width load, we will show you how - but it goes back on before the next steel pipe trip.
Cargo Not Suitable for This Flatbed
We will tell you straight:
- Bulk cement powder or any dry bulk. That is a bulk cement semi trailer job. Bags on pallets are fine; loose powder in the wind is not.
- Liquid tanks or any tanker load. Use the fuel tanker semi trailer line.
- Heavy excavators over 35 tons or low-clearance equipment. A flatbed deck at 1,500mm height is too high for a 40-ton excavator to drive onto. For that job you need a 100-ton low bed trailer with ramps.
- Container-only runs, every single trip. If 90% of your work is port-to-yard container moves, a 3-axle container chassis is lighter and cheaper.
- Heavier 50–60 ton machinery loads. See our 50-ton flatbed trailer for that spec.
For the full general-cargo range, see our flatbed semi trailer catalog. Tell us your top three cargo types (steel, lumber, bagged goods, machinery or containers), and whether your routes run port-to-city or over intercity highways. Our engineers will tailor the stanchion height, number of D-rings and removable sideboard configuration to match your needs, then send you a factory-direct quotation within 24 working hours.
FAQ
Q1: Can the stakes and sideboards be removed when I carry containers?
A: Yes. All 20 stakes pull out of the sockets in under 10 minutes, the sideboards unbolt, and you have a clean container deck with the 12 twist locks exposed. Most of our customers leave stakes in the sockets and just strap around them - they do not interfere with a 40ft box.
Q2: How many D-rings are required for steel pipes compared with lumber?
A: We ship 16 D-rings standard (8 per side). For regular steel pipe runs we add 4 more (2 per side) at the front and rear. For lumber, the stake sockets themselves carry the load, so the standard D-rings are enough.
Q3: Can you build a 45ft or 48ft version for over-length cargo?
A: Yes. We regularly manufacture 45ft, 48ft and 60ft flatbed trailers for long steel, wind tower segments and precast girders. While the 40ft model remains our most popular option, longer decks carry an extra cost of roughly $1,500–3,000, based on the overall length.
Q4: What is the delivery time to Africa / Southeast Asia / Central America?
A: 20–25 working days from deposit for a standard stake flatbed, plus 30–45 days sea freight. Ships by Ro-Ro or flat rack; the stakes and sideboards are shipped loose in a crate to save deck space.
Hot Tags: 3-Axle 40ft Stake Flatbed Trailer — General Cargo Platform for Steel, Lumber and Building Material Haulage, China 3-Axle 40ft Stake Flatbed Trailer — General Cargo Platform for Steel, Lumber and Building Material Haulage manufacturers, factory, Trailer Flatbed, 60 Ton Flatbed Trailer, 48 Feet Flatbed Trailer, Flatbed Container Trailers, Flatbed Truck Trailer, 40 Feet Trailer
Send Inquiry
You Might Also Like










