Operation Manual of Dry Bulk Cement Tanker Trailer
Leave a message
When using the bulk cement trailer, do not exceed speed limit or maximum loading capacity. Otherwise, not only it is dangerous to transport, but also will it damage the air compressor and other parts on the tanker.
Do not start or stop the air compressor too quickly, but slowly increase or decrease the speed. Otherwise, the impulse pressure will be damaged.
Do not change the rotation direction of the air compressor. Otherwise, the machine will be seriously damaged if the oil pump fail to supply oil.
Do not stop the air compressor before decompression. Otherwise, the powder material may flow back into the cylinder causing serious damage to the air compressor.
Check the oil level before starting the machine. The oil level should not be lower than the lowest limit of the oil gauge. It is necessary to check whether the oil pump supplies oil frequently. If it does not supply oil, it must be shut down immediately for inspection. Otherwise, the air compressor will be seriously damaged due to lack of oil.
Replace the lubricating oil regularly. After the machine on a new tanker is used for 30 hours, drain the oil in the crankcase, clean the inside of the crankcase and the oil filter screen, and then change the oil. After that, the oil should be changed once a year with the aforementioned process.
Check and clean the oil filter screen. Under normal working conditions, the tanker shall be inspected and cleaned once every four months. If the utilization rate of the tanker is high, it shall be inspected and cleaned once a month.
The lubricating oil used in the machine must be consistent. It is forbidden to mix lubricating oils of different brands. Otherwise, the deterioration of lubricating oil will affect the lubrication outcome.
Maintain and clean the air filter element every 30 hours. While rotating the filter element, blow compressed air with pressure less than 0.6MPa fro






