Operation Method Of Bulk Cement Tanker Trailer
Leave a message
1. Do not run over speed and pressure when driving bulk cement tanker trailers, overspeed, overpressure will seriously damage the air compressor. The maximum speed of this machine is shown in the main technical parameter table, and the working pressure is 0.2MPa.
2. Do not start or stop the air compressor quickly, but slowly increase or slow down, otherwise, the punching force will damage the air compressor.
3. Do not change the rotation direction of the air compressor, otherwise, the oil pump will seriously damage the machine if it is not supplied with oil.
4. Do not stop the air compressor before depressurization, otherwise, the powder material may flow back into the cylinder, causing serious damage to the air compressor.
5. Check the oil label before starting. The oil level shall not be lower than the lower limit of the oil standard; It is necessary to check frequently whether the oil pump is supplied with oil, if it does not supply oil, it should be stopped immediately for inspection, otherwise, the lack of oil will seriously damage the air compressor.
6. Change the lubricating oil on schedule. After 30 hours of use of the new machine, drain the oil in the crankcase, clean the inside of the crankcase and the oil filter screen, and then change the oil. In the future, change the oil once a year as described above.
7. To check and clean the oil filter screen. Normal conditions: inspection and cleaning every quarter, if the machine utilization rate is high, should be inspected and cleaned once a month.
8. The lubricating oil used in this machine is CD40 diesel engine oil. It is forbidden to mix different grades of lubricating oil, otherwise the deterioration of the lubricating oil will affect the lubrication effect.
9. Every 30 hours of work, the air filter should be maintained and cleaned. While turning the filter element, use compressed air with a pressure of less than 0.6MPa to blow from the inside to the outside. After five maintenances, replace the filter with a new one. It is strictly forbidden to clean the filter element with oil or water.
